Free Shipping on all Inverters, Controllers, E-Panels and Accessories !

 

Primus 27 Foot Guyed Tower Kit

$399.00

Easy Set up – Affordable Price!
A Reliable Tower in Demanding Environments.
Does Not Include Shipping. Please phone or email.

SKU: Primus27 Category:

Description

Primus 27 Foot Guyed Tower Kit

Manual

air1This tower kit is designed specifically for the Primus Wind Power AIR 30 and AIR 40 wind turbines. This is the most economical and user friendly tower kit available for the “AIR” wind turbines. Guy wire supported construction allows the use of lightweight tubing while providing plenty of strength for all but hurricane conditions.
Two people can easily erect a tower with this kit in an hour or so. Since the turbine and the tower kit are light in weight, no winches, vehicles or beasts of burden are needed to erect the tower. All that is required is a little bit of “elbow grease”.

We recommend that at least two people be present when the tower is raised, although it is conceivable that a single person could actually raise a tower on their own.
The AIR tower kit includes a simple yet effective elbow/tee for its base. Combined with a short length of tubing this type of base eliminates the need for a concrete pad, base plate and a swivel for the base of the tower. A simple extruded aluminum, coupling clamp allows the use of a wide selection of different kinds of tubing, depending on availability, site requirements and customer preference. Threaded coupling points are eliminated, allowing lighter materials to be used with the same or greater strength than a threaded pipe tower. Pre-cut and swaged guy wires eliminate wire measuring and cutting.
We believe this kit and assembly method is the easiest way possible to put the AIR wind module up in the air.

Primus 27 Parts

Due to the high cost of shipping and the widespread availability of the tubing or pipe used with these towers these materials are not supplied with the kit. The AIR wind module is designed to be mounted on a 1.875 in. outside diameter pole. This is the same outside diameter as 1 ½ in. steel water pipe where the “1 ½” is a nominal size indicating an outside diameter that is actually 1.875 in.
The design of this tower kit allows pipe (or tubing) of various different wall thickness to be used depending on the severity of the wind at your site location.
Use the following table to determine the acceptable pipe size(s) for your tower and wind severity.
In most locations structural steel tubing with a wall thickness of .065 inches is sufficient for the conditions and preferable in terms of cost and ease of assembly. Electrical conduit must be avoided for use in your tower assembly, since it is generally not designed for strength.

Pipe Chart

Additional information

Weight 10 kg
Dimensions 90 x 30 x 20 cm

You may also like…